These Genuine PowerMatched Premier II remote control cables are unlike any other cables on the water. They're perfectly matched to your Yamaha outboard and its controls. Features: A stainless steel core with special nylon covering using plastic-on-plastic technology that increases cable performance A splined inner core for ultra-low friction and reduced end play A 45% reduction in cable friction (vs. standard marine cables) for smoother operation A 4" bend minimum radius offers superior flexibility and easier rigging Stranded core wires increase strength and resist kinking Exposed metals are stainless steel to help protect against corrosion An ultraviolet-stabilized jacket resists cracking and water migration to the core Factory-installed anti-corrosion materials extend the life of the cables Wide selection of lengths available (4'-40') NOTE: When determining the correct cable length for your application, be sure to add the distance from the center of the engine to the bilge area through the rigging tube, from that point to the gunnel (usually starboard) where the cables will run to the console, the length of the gunnel or rigging tube, and the distance from the gunnel to the console where the remote control box will be located - then add two feet. This extra distance will allow for any errors in measurement and ensure sufficient bend radius for smooth, easy shifting.
This Yamaha Yamaha PREMIER II CABLE 6 F part is also used on these models and components: